I am new to the forum and to using RAZE. I have very little experience with GZDoom/ZDoom as a Doom source port/engine and zero experience with using RAZE. I am currently playing through PowerSlave (DOS Classic Edition) on Steam and the game keeps crashing. I have attached the report text file that is created after the game has crashed and a screenshot of what the report says if a report is created or not. I have tried all three different graphics options available: Vulkan, OpenGL and OpenGL ES. When I choose the Vulkan graphics settings and if I am quick enough and don't turn around, I can move around in previous parts of the level without the game crashing, however, when I go back to that area, it crashes. I doubt this is of any consequence as it still crashes not matter with graphics I select. I have been using Open GL until I started testing after the game started to crash. Please see info in SPOLIER below.
SPOILER:
I was in the spaceship toward the end of the game, climbing down the rock wall when it began to crash. I managed to get down the brick wall and destroy a power cell and once I try to walk out or even wait and do nothing, it will crash within a few seconds.
I used this guide to get RAZE running on Steam with the overlay: Powerslave Classic: Modern Build By erc, but only installed RAZE and not both RAZE and SteamEdit.
Please advise, as I am enjoying the 90's all over again.
