ZDoom

so im making a map using UDB and i have a speed puzzle that builds stairs upon pressing a switch, my issue is that i wanted a timer on it but the reset delay for stairs build up (doom mode) can only go up to 10 sec while i need it to be 20 seconds
any ideas on what im doing wrong ?

Setting the reset to 20 seconds (i.e. 20*35 tics) works fine for me.

it just resets back to 0 if i try to imput anyrhing else than the presets

How are you entering the number? There seems to be a quirk that when you have the drop-down menu open, enter a number, and then press enter, it seems to use the highlighted value. So make sure that the drop-down menu is not open.

i tried entering it manually without highlighting aniting the value entered was 700: 20 seconds
but it reverts back to zero after applying

Gonanza wrote: ↑Sun Jun 08, 2025 8:18 am i tried entering it manually without highlighting aniting the value entered was 700: 20 seconds
but it reverts back to zero after applying

You can enter 700 either way

Spoiler:

---

did you set up the stair sectors properly?

Spoiler:

---

with emphasis on the linedef directions

it worked i just had to put 700 and nothing else im so dumb thx guys

https://www.youtube.com/watch?v=H-fQy7M_v_w