No Gravity for Things

Post by **Kappes Buur** » Sun Aug 17, 2003 8:35 pm

How can I apply NO GRAVITY to:

9029 Particle Fountain Blue
9030 Particle Fountain Yellow
9033 Particle Fountain White

with either DeHackEd or BOOMdeh?

Zell · Post by **Zell** » Sun Aug 17, 2003 8:35 pm

why? =p u could use Zheight to susped them in air.

Post by **Kate** » Sun Aug 17, 2003 8:36 pm

They're already no-gravity, you just have to set their vertical height in the editor you're using.

Post by **Kate** » Sun Aug 17, 2003 8:37 pm

Whoop, Zell got to it before me!

Post by **Kappes Buur** » Sun Aug 17, 2003 8:50 pm

That is my problem.

I did give them a z-value, but they are still sitting on the bottom of the pool instead of on top of the water surface.

Sphagne · Post by **Sphagne** » Sun Aug 17, 2003 9:16 pm

Have you tried to give it more haight and also raise the ceiling to give it more room, or maybe test and tackle with it in a test map and when you are sure with it then use it in actual levels.

Biff · Post by **Biff** » Sun Aug 17, 2003 9:43 pm

If you put zero z offset, the particles should appear at the floor, underwater, and up to about 40 units. You have to give them a +z offset close to the depth of the water.

Post by **Kappes Buur** » Sun Aug 17, 2003 9:55 pm

I got it working.

I made the wrong assumption that the z-value refers to the height of the waterline. Instead it is the offset from the bottom of the pool.

Thanx