Textures on a FLAT

Galaxy_Stranger · Post by **Galaxy_Stranger** » Thu Dec 16, 2004 5:01 pm

is there a way to rotate textures that have been placed on a FLAT? or do you just have to flip the graphic and put it in?

PlzDieKthx · Post by **PlzDieKthx** » Thu Dec 16, 2004 5:14 pm

Post by **randi** » Thu Dec 16, 2004 6:21 pm

Galaxy_Stranger · Post by **Galaxy_Stranger** » Thu Dec 16, 2004 9:05 pm

oh, SWEET, that's perfect!

I always thought that was to rotate the sector itself via a switch or whatever.

Post by **Kirby** » Thu Dec 16, 2004 11:16 pm

Galaxy_Stranger wrote:oh, SWEET, that's perfect!

I always thought that was to rotate the sector itself via a switch or whatever.

Hehe, I coulda told ya about that. I asked a question about that with ceiling fans once but only to be disappointed.

HotWax · Post by **HotWax** » Thu Dec 16, 2004 11:54 pm

Galaxy_Stranger wrote:oh, SWEET, that's perfect!

I always thought that was to rotate the sector itself via a switch or whatever.

If only this were possible. ^_^

Galaxy_Stranger · Post by **Galaxy_Stranger** » Thu Dec 16, 2004 11:55 pm

i coulda swore that's what I saw the demo .wad doing.

HotWax · Post by **HotWax** » Thu Dec 16, 2004 11:56 pm

Are you sure you're not confusing sector movement with polyobjects?

Galaxy_Stranger · Post by **Galaxy_Stranger** » Thu Dec 16, 2004 11:58 pm

yeah, i'm sure. it would rotate this raised floor a few inches every time you used the switch.

Post by **Kirby** » Fri Dec 17, 2004 12:19 pm

Galaxy_Stranger wrote:yeah, i'm sure. it would rotate this raised floor a few inches every time you used the switch.

Would it rotate the lower textures?

Galaxy_Stranger · Post by **Galaxy_Stranger** » Fri Dec 17, 2004 1:46 pm

you know, I can't remember. I'll just have to download the .wad again and check it out.

wildweasel · Post by **wildweasel** » Fri Dec 17, 2004 8:20 pm

You don't think it was a bunch of lifts, do you? I remember seeing a similar wad (cogwheel.wad at the XWE site I believe) that did that.