is there a Floor_offset(tag,xamnt,yamnt)\Ceiling_offset(tag,xamnt,yamnt) command?
because floor_align(tag,side) dosent always work right (aligns to the wrong side etc)
which means i have 8 copies of practicly the same flat (different offsets) which adds a whole 158K to the size (go get cable)
floor_offset\ceiling_offset command
Forum rules
Before asking on how to use a ZDoom feature, read the ZDoom wiki first. This forum is archived - please use this set of forums to ask new questions.
Before asking on how to use a ZDoom feature, read the ZDoom wiki first. This forum is archived - please use this set of forums to ask new questions.
-
Bio Hazard
- Posts: 4019
- Joined: Fri Aug 15, 2003 8:15 pm
- Location: ferret ~/C/ZDL $
- Contact:
-
Bio Hazard
- Posts: 4019
- Joined: Fri Aug 15, 2003 8:15 pm
- Location: ferret ~/C/ZDL $
- Contact: