SLADE Discussion - Latest: v3.2.7 (25/Dec/2024)

[bimshwel]

oh, yes, it does, thank you!

[ReX]

This should be fixed in 3.2.8

Thank you, sir.

[ReX]

This should be fixed in 3.2.8

I originally took this to mean that the issue had been fixed and v3.2.8 had been released. However, the SLADE downloads page only shows up to v3.2.7. I take it you meant that the issue will be fixed in the next version., correct?

[bimshwel]

it has been fixed in this special version of of 3.2.7 https://github.com/sirjuddington/SLADE/ ... 2794097207 that I guess the download page was not updated with.

[ReX]

it has been fixed in this special version of of 3.2.7 https://github.com/sirjuddington/SLADE/ ... 2794097207 that I guess the download page was not updated with.

Thanks. I am currently not in a pressing need for the feature I was requesting, so I'll just wait for the official 3.2.8 release. However, if the need arises, I will download and use the updated v3.2.7.

[Blue Shadow]

I have two physically separate sectors that are joined as one. I'd like to split them so each is its own sector. Is there a way to do this?

[Enjay]

I use UDB for mapping but I think if you move your mouse over one of the areas, all of the various sector parts will flash-highlight. However, if you press Insert (assuming default key-binds) the one that your mouse is over will be allocated as a new sector.

[Edit:] Yes, on a quick try, that worked. FWiW, in UDB the same thing can be achieved by pressing M for make sectors mode and then clicking on the areas that you want to become their own separate sectors.

[Blue Shadow]

Thanks.

I already know about the make sectors mode in UDB. I just wanted to know if I can achieve a similar thing in SLADE because that's what I'm using for mapping currently, even though I have UDB installed, too.