Setting specific pivot point for ROLLSPRITE

Post by **Jekyll Grim Payne** » Sat Jun 01, 2019 11:13 am

Center or 0,0 coordinates is extremely limiting. Creating anything like a swigning ceiling lamp while also making it solid an easily placable in the map is very awkward. We really need this.

Darkcrafter · Post by **Darkcrafter** » Fri Jun 14, 2019 11:00 am

Can you demonstrate what you need? I really don't see any trouble on placing a sprite of lamp on a ceiling and why it should be rotated?

Matt · Post by **Matt** » Fri Jun 14, 2019 12:40 pm

Basically right now you can easily use rollsprite to make one of these wobble
https://www.amazon.ca/Century-Bob-Body- ... B00329TVEM

but not one of these
https://www.amazon.ca/Everlast-Powercor ... B004CY3VD8

If exact coordinates are unworkable a rollaxis property just for up/down (maybe 0.-1. (or even lower or higher #s for a bigger offset) as a proportion of the sprite size?) would be nice too.

Post by **Major Cooke** » Sun Jun 16, 2019 12:43 pm

If this piggybacks off that one suggestion of making sprites offsettable, that'd be perfect.

ZDoom