[REQUEST] Single angled idle frame for this shotgun
Forum rules
The Projects forums are only for projects. If you are asking questions about a project, either find that project's thread, or start a thread in the General section instead.
Got a cool project idea but nothing else? Put it in the project ideas thread instead!
Projects for any Doom-based engine (especially 3DGE) are perfectly acceptable here too.
Please read the full rules for more details.
The Projects forums are only for projects. If you are asking questions about a project, either find that project's thread, or start a thread in the General section instead.
Got a cool project idea but nothing else? Put it in the project ideas thread instead!
Projects for any Doom-based engine (especially 3DGE) are perfectly acceptable here too.
Please read the full rules for more details.
-
IvanDobrovski
- Posts: 83
- Joined: Mon Aug 08, 2016 4:05 am
[REQUEST] Single angled idle frame for this shotgun
This shotgun made by Craneo, can anyone make an angled idle frame for it?
- Attachments
-
-
Craneo
- Posts: 248
- Joined: Sat Jun 22, 2019 9:12 am
- Graphics Processor: Intel (Modern GZDoom)
- Location: Gone.
Re: [REQUEST] Single angled idle frame for this shotgun
ANGLED CREDITS:
ID Software, 3D Realms, Gearbox Software, DoomNukem, Kofeinoe_Zerno, TypicalSF, Craneo
-
IvanDobrovski
- Posts: 83
- Joined: Mon Aug 08, 2016 4:05 am
Re: [REQUEST] Single angled idle frame for this shotgun
Thanks a lot!Craneo wrote: ANGLED CREDITS:
ID Software, 3D Realms, Gearbox Software, DoomNukem, Kofeinoe_Zerno, TypicalSF, Craneo