Page 1 of 1

[Request]Cleaned up Heretic 2 model rip.

PostPosted: Sun Oct 03, 2010 6:09 am
by Killar
Please clean up this model rip for me:
sparta4.png

Re: [Request]Clean up this Heretic2 model rip.

PostPosted: Sun Oct 03, 2010 6:12 am
by SoulCrow
You should probably ask more politely rather than just saying "I need this done, I need that done" otherwise nobody is going to pay any attention.

Re: [Request]Cleaned up Heretic 2 model rip.

PostPosted: Sun Oct 03, 2010 6:59 am
by .+:icytux:+.
what the fuck is that?

can you be more specific as to how you want it to look?

Re: [Request]Cleaned up Heretic 2 model rip.

PostPosted: Sun Oct 03, 2010 7:15 am
by Killar
It's a Heretic 2 Sidhe Shrine.

I want it to look like it is a Heretic sprite.

Re: [Request]Cleaned up Heretic 2 model rip.

PostPosted: Sun Oct 03, 2010 7:57 am
by Doomfreak
IT_IS_SPARTA!.png

Here,I combined some heretic keys and then greyscaled it,this was the result. ^

Re: [Request]Cleaned up Heretic 2 model rip.

PostPosted: Sun Oct 03, 2010 9:40 am
by Killar
That would work for a powerup I'm going to make, but I also want a sprite of the shrines.(From the model rip) I went through a lot of trouble getting it like that, but I want to use it as a shrine too.

Re: [Request]Cleaned up Heretic 2 model rip.

PostPosted: Sun Oct 03, 2010 2:36 pm
by neoworm
How did you managed to view Heretic 2 models? I tought there is no software availible to open its format.

Re: [Request]Cleaned up Heretic 2 model rip.

PostPosted: Sun Oct 03, 2010 3:41 pm
by Gez
The problem with using a sprite for the shrines is that they're big static models. (Taller, wider than the player.) They are going to look bad if they're full scale. Sprites don't work well for large things (even the spiderdemon is pushing it), and they work even more poorly for static things.

Re: [Request]Cleaned up Heretic 2 model rip.

PostPosted: Sun Oct 03, 2010 4:51 pm
by Ichor
In this case, you're better off using a few 3d floors in GZDoom to make the shrine.