Page 1 of 1

GetExplosionFalloff()

PostPosted: Fri Oct 20, 2017 8:34 am
by Major Cooke
GetExplosionFalloff(actor target, damage, distance, full radius distance)

All it does is calculate how much damage would be done to a target based on falloff, based on distance from the calling actor to the target. I suggest this because the radius explosion code seems to perform quite a few calculations which would be best suited for staying in the engine. It's basically a harmless version of A_Explode for one actor.

Re: GetExplosionFalloff()

PostPosted: Thu Jul 25, 2019 4:26 am
by Blue Shadow

Re: GetExplosionFalloff()

PostPosted: Thu Jul 25, 2019 4:31 am
by Nash
Did you forget what you added, Cooke? :mrgreen:

[EDIT] Ah didn't read Cooke's OP date, woops my bad

Re: GetExplosionFalloff()

PostPosted: Thu Jul 25, 2019 4:34 am
by Rachael
This is a very old thread.

Re: GetExplosionFalloff()

PostPosted: Thu Jul 25, 2019 5:29 am
by Blue Shadow
I could stop doing these bumps if they're going to cause confusion or annoyance. In the end, nobody told me to do this, anyway.

Re: GetExplosionFalloff()

PostPosted: Thu Jul 25, 2019 6:46 am
by Graf Zahl
If you want to scan through the forum to weed out the slack, I think it'd be preferable to allow you to move them yourself.

Re: GetExplosionFalloff()

PostPosted: Thu Jul 25, 2019 6:56 am
by Rachael
Blue Shadow wrote:I could stop doing these bumps if they're going to cause confusion or annoyance. In the end, nobody told me to do this, anyway.


Hey, if you wanna help out with these things, I am *NOT* going to look a gift horse in the mouth. It's very much appreciated! :)

Graf Zahl wrote:If you want to scan through the forum to weed out the slack, I think it'd be preferable to allow you to move them yourself.


Good idea.

Thus, it is done. Now you have topic tagging access, Blue Shadow, and you should be able to move things to Closed with a tag.