Ask about mapping, UDMF, using DoomBuilder/editor of choice, etc, here!
Forum rules
Before asking on how to use a ZDoom feature, read the
ZDoom wiki first. If you still don't understand how to use a feature, then ask here.
by Paar » Mon Nov 19, 2018 2:12 pm
When I use the Ceiling_CrushAndRaise function in ACS I get different descend and ascend speeds. Descend speed works properly (as defined in the function argument) but when the crusher goes up the speed is slower. Is this normal? To get the same speeds I have to use Ceiling_CrushAndRaiseA and make both values the same.
Tested on GZDoom 3.6.0.
- Attachments
-
crushers.wad
- (9.53 KiB) Downloaded 3 times
-
Paar
-
- Joined: 18 Apr 2008
by Paar » Wed Nov 21, 2018 3:07 am
I had the wiki open but didn't notice the part about ascending speed being halved. Sorry about that, I'll be more careful next time. Thank you.
-
Paar
-
- Joined: 18 Apr 2008
Return to Mapping
Who is online
Users browsing this forum: No registered users and 1 guest